I installed a replacement ceiling fan (Hunter). All works fine, except that if you turn it on and off by the? - hunter ceiling fan replacement parts
Standard wall switch, it immediately begins to reverse, and you have to go back to the summer and winter, the fan instead of rising air. I do not see a switch to change this behavior in the long term, but of all time. Ideas? I think I followed the instructions on the wiring of the T.
Hunter Ceiling Fan Replacement Parts I Installed A Replacement Ceiling Fan (Hunter). All Works Fine, Except That If You Turn It On And Off By The?
5 comments:
I know your problem. I have a Hunter fan, and you do not have a wiring problem! Works great with the remote but can not invest because the changeover. Try this! You must have a power light and fan switches on the wall. There are three small switches for each. Everything that is you have to do is press the fan and light switches at the same time and in one or two seconds, you get two sounds that are heard thrice. The fan will be invested in the opposite direction. Make sure the fan so you can invest. Dollars to donuts this job! Good luck!
How can we reverse direction when the opposite?
The only control is a slide switch on the side of the motor housing. Normally, it slipped so set that turns the fan in the winter break mode (air). In the lower position to reverse the flight down (summer). Make sure that the rotation is completely stopped before changing direction. So you do not mention whether the fan is a lightweight unit with a separate switch for the drive unit. Pull the string to the fan motor is usually next to the motor housing. The wiring, which exists in the zone boundary must be black (the power of the switch) to black wire of the fan. White is neutral and goes all the way back to your cabinet. Should be able to unless the cable from the switch and is used to move a leg. As a neutral white wire should go to the fan. The red wire goes to the lighting circuit of the fan. Usually a red tie and black son together fan when the power is a switch. Together, they are connectedInput power switch. The green wire and cable bare copper grounding belong together and should never power over them at any time. Sounds like it is the slider to his problem, you are three son about) (center of power and have depending on its position sends the power on one side of the engine or the other to control the rotation. Only one other possibility would be from a remote (wireless doubt be executed) and a reset in I (). If you remove have time, the knife and try the son of black and white for a switching power supply connected and you try, the problem can no longer occurs. Make sure that cable is actually black power cord and the white cable is really neutral.
Good luck! ! !
I think the guy was the first good idea .... have confidence in me son crossed wires ..
I think the guy was the first good idea .... have confidence in me son crossed wires ..
If there is a change for the motor. Everything he does is cross-son, when connected with wire nuts. It is not true, the son left the Miss ceiling can be represented. The wall switch permanently from the ground. It is necessary to create the heat, and turn on the field with a tester.
Post a Comment